ISO/IEC17025 accredited calibration
QIs HIOKI able to perform the ISO/IEC17025 accredited calibration? Is there any list detailing what you can offer?
A
Select your region & language
Americas
Europe
Southeast Asia, Oceania
India
Calibration at a specific point
QI want to calibrate an instrument at a specific point. Is it possible to calibrate at a point I specify?
A
Conditions required for safe measurement of voltage exceeding 1000V DC [ DMMs, Clamp on meters ]
QThe 1500V range of my CM4374 is CAT IV 600V/CAT III 1000V. Is there any requirement for safe measurement?
A
Lower FAIL displayed in withstanding voltage test
QI am getting a "Lower FAIL" reading even though I tested the withstanding voltage of a known-good product.
A
Negative resistance value on a DMM
QMy DT4253 displays "-40 ohm" in resistance measurement. Why does this happen?
A
Timer calibration of withstanding voltage tester
QI would like to calibrate the timer of the 3153. When I set the timer to 1s, it takes about 1.3s to confirm the output voltage. Is the unit defective?
A
Can I use the heat flow sensor with the LR8515?
QCan I use the Z2013 Heat Flow Sensor with the LR8515?
A
Strange analog (D/A) output from the PW3335
QI use the PW3335-02 by connecting its analog output to a data logger. However, the output value does not match the PW3335 display.
A
10ms sampling of the LR8431
QIs it possible to use the 10ms interval for all 10 channels on the LR8431?
A
Difference between the LR8431 and LR8432
QIs there any difference between the LR8431 and LR8432 other than heat flow measurement?
A