Temperature compensation of the Battery Tester
QCan the BT3554 compensate for temperature by using the optional 9460 Clip Type Lead with Temperature Sensor?
A
Select your region & language
Americas
Europe
Southeast Asia, Oceania
India
Measurement cable of the earth tester
QCan I use the measurement cables of the FT3151 Earth Tester (L9482-11, L8482-22) with my old 3151 Earth HiTester? Also, can I use the Auxiliary Earthing Rod L9840 with the 3151?
A
Conditions required for safe measurement of voltage exceeding 1000V DC [ DMMs, Clamp on meters ]
QThe 1500V range of my CM4374 is CAT IV 600V/CAT III 1000V. Is there any requirement for safe measurement?
A
Timer calibration of withstanding voltage tester
QI would like to calibrate the timer of the 3153. When I set the timer to 1s, it takes about 1.3s to confirm the output voltage. Is the unit defective?
A
Difference between the LR8431 and LR8432
QIs there any difference between the LR8431 and LR8432 other than heat flow measurement?
A
Effective measurement range of power quality analyzer
QThe voltage range of the PQ3198 is 600V only. Is it possible to measure a 690V circuit?
A
Want SDS: Safety Data Sheet (MSDS: Material Safety Data Sheet)
QI need an SDS: Safety Data Sheet (MSDS: Material Safety Data Sheet).
A
Use of mercury content
QDoes any HIOKI products use/contain mercury
A
Calibration at a specific point
QI want to calibrate an instrument at a specific point. Is it possible to calibrate at a point I specify?
A
Lower FAIL displayed in withstanding voltage test
QI am getting a "Lower FAIL" reading even though I tested the withstanding voltage of a known-good product.
A