Current output function of the sensor unit
QI'm using Hioki high performance current sensors connected to a sensor unit. Can I output WAVE output and RMS output at the same time? (Sensor Unit CT9555, CT9556, CT9557)
A
CT9556 and CT9557 can output simultaneously.
The functions of WAVE output and RMS output for the three models are as follows.
1. Sensor Unit CT9555
WAVE output (front side)
2. Sensor Unit CT9556
WAVE output (front side)
RMS output (back side)
3．Sensor Unit CT9557
WAVE output (front side) BNC (female) × 4 channels
Addition RMS output*1 (back side) BNC (female)
Addition WAVE output*2 (back side) BNC (female)
Addition WAVE output (back side) Hioki ME 15W (male)
*1 Addition RMS output:
Adds the waveform signal of the sensor that is connected to the channel with the TOTAL OUTPUT switch ON, which converts it to RMS, and then outputs as DC voltage.
*2 Addition WAVE output:
Adds the waveform signal of the sensor that is connected to the channel with the TOTAL OUTPUT switch ON, and outputs as a waveform signal.
