Loss due to the instrument connection method
QDo measured values vary with the power meter connection?
A
Select your region & language
Americas
Europe
Southeast Asia, Oceania
India
Differences between the 3390 and 3390-10
QHow do the functions of the 3390 and 3390-10 differ?
A
How do I record a 4 to 20 mA instrumentation signal?
QI’d like to record a 4 to 20 mA measurement signal with my Memory HiLogger, but the instrument lacks a suitable measurement range. Is there a method I can use to record this signal?
A
Difference between a Memory HiCorder’s maximum rated voltage to earth and its maximum input voltage
QIn the specifications for a Memory HiCorder input unit, a maximum rated voltage to earth as well as a maximum input voltage are listed. What is the difference between these two characteristics?
A
How can the 3665 measure LAN cable length?
QHow is cord length measured?
A
The polarity (+/-) was reversed when I made a measurement using the resistance range. Is the instrument broken?
QI have a question about an analog tester. The polarity (+/-) is reversed when performing measurements with the resistance range. Why is this? Wouldn’t this invite mistakes, for example when checking diode polarity?
A
Inability to start a withstanding test
QWhen I try to start the test, measurement does not start.
A
Infrared thermometer measurable temperature range
QHow far away can an infrared thermometer take readings?
A
Clamp sensor voltage to earth
QThe specifications for the Clamp On Leak HiTester 3283 indicate a maximum rated voltage to earth of 300 V rms AC (insulated conductor) (CAT III, 300 V). Can the 3283 be used to measure a 3-phase 400 V circuit?
A
Error upon connection check
QThe instrument indicates an error when it checks the connection, even though it is connected properly.
A