IMPEDANCE ANALYZER IM7587-01 IM7587-02
V1.05 Feb 29, 2024
- If you are unable to download software, please check the following:
- Please register a my HIOKI account and then use it to log in to the my HIOKI service.
- Product firmware (product upgrades) and computer application software can only be downloaded for products you have registered on the my HIOKI service.
| Firmware (IM7587V105.zip) | |
|---|---|
| Procedure on how to update the firmware (IM7580S_SoftwareUpgradeManual_3.pdf) |
Version upgrade should be conducted by a qualified technician familiar with the functions and operations.
If you are uncertain as to how to proceed, please contact your local HIOKI distributor for assistance.
・All software provided here is the best version currently available.
・If the problems or errors during this download and install lead to malfunction, please contact your dealer or Hioki representative.
・The ownership, intellectual right and all other associated rights relating to the software provided here belong to Hioki E.E. Corporation.
If you have read and understand the information above and wish to proceed then please download the designated files.
As for version upgrade procedure, please download "Procedure on how to update the firmware" which describes the preparation and procedure for upgrading firmware after downloading the files.
Precaution when updating firmware:
・To conduct the version upgrade, USB memory is required.
・During the version upgrade process, don't turn off the power to the IM7587 or don't remove the USB memory from the slot.
・Please do not downgrade IM7587 to anything other than the latest version.
Also, do not change them to a bespoke version.
Normal measurement may not be possible.
Firmware for the Model IM7587
The current newest software versions are shown below. A version update is highly recommended if you are running older firmware.
Version :V1.05
Before you proceed
The version number of firmware can be checked by selecting the “INFO” tab of the System screen.
Version Upgrade History
V1.05 (February 2024)
Bug fixes
・Fixed the problem that the Model E of equivalent circuit analysis, when the frequency type of electromechanical coupling coefficient is fr-fa and the phase is not zero-crossed, the analysis does not work properly.
Improved
・Minor problem was fixed.
V1.04 (August 2020)
Bug fixes
・The measuring instrument stops working when equivalent circuit analysis is performed with the folloing settings.
-1.The model setting is AUTO, and the method setting is MANUAL.
Function addition
・Added support for the use of the control characters LF as a command terminator.
V1.03 (October 2019)
・Minor changes.
V1.01 (July 2017)
Repaired bug:
・When using the following commands, it was unable to set to off.
:CORRection:CALIbration:OPEN:LIMit OFF
:CORRection:CALIbration:SHORt:LIMit OFF
:CORRection:CALIbration:LOAD:LIMit OFF,OFF
:CORRection:COMPensation:OPEN:LIMit OFF
:CORRection:COMPensation:SHORt:LIMit OFF