IMPULSE WINDING TESTER

IMPULSE WINDING TESTER

V1.04  Dec 13, 2019

If you are unable to download software, please check the following:

  • Please register a myHioki account and then use it to log in to the myHioki service.
  • Product firmware (product upgrades) and computer application software can only be downloaded for products you have registered on the myHioki service.

  • firmware(ST4030_V1.04.zip)

    DOWNLOAD

  • version upgrade procedure(ST4030SoftwareUpgradeManual.pdf)

    DOWNLOAD

Version upgrade should be conducted by a qualified technician familiar with the functions and operations.
If you are uncertain as to how to proceed, please contact your local HIOKI distributor for assistance.
・All software provided here is the best version currently available.
・If the problems or errors during this download and install lead to malfunction, please contact your dealer or Hioki representative.
・The ownership, intellectual right and all other associated rights relating to the software provided here belong to Hioki E.E. Corporation.

If you have read and understand the information above and wish to proceed then please download the designated files.
As for version upgrade procedure, please download "ST4030SoftwareUpgradeManual.pdf" which describes the preparation and procedure for upgrading firmware after downloading the files.
The version upgrade results in changes to the instruction manual. Please download "ST4030A971-00.pdf" which describes the details of the improvements.

Precaution when updating firmware:
・To conduct the version upgrade, USB flash drive is required.
・During the version upgrade process, do not turn off the power to the ST4030 and do not remove the USB flash drive from the slot.

Firmware for Model ST4030

The current newest software versions are shown below. A version update is highly recommended if you are running older firmware.
Version :V1.04

Before you proceed

The firmware version is displayed on the INFO tab of the SYSTEM screen.

Version Upgrade History

V1.04  (December 2019)
・Unified the firmware for the ST4030 and ST4030A.
・When the settings saved in ST4030A are loaded into the ST4030, only settings that can be output by the ST4030 are read.
・Fixed minor bugs.

V1.02 (September 2019)
・Increased the number of response waveforms that can be evaluated.
・Improved usability with respect to creating threshold values.
・Fixed minor bugs.